• The hot cutter unit separates from the extruder / The die and the inside of the cutter hood can be easily cleaned.By moving the main unit of the hot cut equipment on the slide rail or casters, it can be easily separated from the extruder and the inside of the die can be easily cleaned. The inside of the cutter hood can also be easily cleaned by retracting the cutter hood and motor.

• Changeable pellet cut lengthBy changing the motor speed, the cut length of the pellets can be changed.

• Changeable number of cutter blades / Settable cutting speed suited to the pellet propertiesCutter blades can be selected from 2 or 4 blades and combined with the motor speed, can set a cutting speed suitable to the pellet properties.

• Supports various fluid dischargeBy changing the fluid supplied to the hood, the equipment can easily change between hot cut (air-cooled), water ring (water cooled), and mist cut (mist-cooled).

• When used as hot cut (air-cooled) equipment Select the air-cooled hot cut equipment with resins averse to the adhesion of moisture. The flow of supplied air ejects cut pellets out the hood chute while cooling them. Ejected pellets are transported air-cooled to the designated location by the pneumatic conveyance equipment.

• When used as mist cut (mist-cooled) equipment Select the mist cut method when pellets do not require as much cooling as the water ring, but they do require a certain level of rapid cooling. The water and air supplied to the hood turn into mist, pellets in the hood are cooled as they are transported to the outlet. Ejected pellets are transported to the designated location by the pneumatic conveyance equipment.

• When used as water ring (water-cooled) equipment Select the water ring when pellets of a resin that easily resists water require rapid cooling after being cut. Since the system uses a comparatively large amount of water with a centrifugal dryer, the water in the dryer is circulated back to the hood by an electric pump. Dried pellets are ejected from the dryer outlet.